Adder VSCD10A – 2m DisplayPort 1.4 HBR3 Cable

Product Overview

The Adder VSCD10A is a 2-meter male-to-male DisplayPort cable supporting DisplayPort v1.4 with HBR3 (High Bit Rate 3) data rates, specified by Adder for use with the ADDERLink INFINITY 4000 (ALIF4000) series. When a KVM endpoint is built to carry high-resolution video, the local DisplayPort patch cable must sustain the full HBR3 link rate — and this Adder DisplayPort 1.4 cable is the vendor's own answer to that requirement. It is the dependable choice for connecting ALIF4000 transmitters and receivers to sources and displays at full bandwidth.

Product Description

High-performance IP KVM systems such as the ADDERLink INFINITY 4000 move uncompromised, high-resolution video between computers and operator positions — but the short DisplayPort hops at each end of the link are only as good as the patch cables used. A cable that cannot sustain HBR3 signaling forces link training down to lower rates, costing resolution or refresh capability that the system was specified to deliver. The VSCD10A removes that risk: it is built and listed by Adder for DisplayPort v1.4 / HBR3 operation and validated for use with the ALIF4000 range. The 2m length suits the typical distance from a rack-mounted transmitter to a host machine, or from a receiver to desktop displays at an operator console, without coiling excess cable behind equipment. Standard male DisplayPort connectors at both ends mean it also serves as a known-good DP 1.4 patch lead anywhere in the facility where full-bandwidth DisplayPort is required. Specifying vendor-listed cables across a KVM deployment keeps link behavior consistent and makes faults easier to isolate when troubleshooting. Source ALIF4000 hardware and matching accessories from the Adder Technology collection at Creation Networks.

Key Features

• DisplayPort v1.4 with HBR3 support — Sustains High Bit Rate 3 data rates so high-resolution KVM links run at full specified bandwidth.
• Listed for ADDERLink INFINITY 4000 — Adder specifies the VSCD10A for use with the ALIF4000 series, removing cable-compatibility guesswork.
• Male-to-male DisplayPort connectors — Connects sources, transmitters, receivers, and displays directly with no adapters.
• 2-meter length — Sized for rack-to-host and receiver-to-display runs without excess slack behind equipment.
• Consistent vendor-matched signal path — Standardizing on Adder-listed cables simplifies commissioning and fault isolation across a deployment.

Technical Specifications