Accessories that mount to a Salamander cabinet's own frame — tech shelves and brackets for cameras, soundbars and codecs, rack rails, doors, feet, casters and finish panels.

Check the mount prefix before ordering

This is the detail that most often goes wrong. Salamander uses three mounting systems and they are not interchangeable:

• SA — Integrated Mount. Fits the cabinet frame directly. These are the parts on this page.
• FI — Factory Installed. Same component, fitted at the factory rather than on site.
• FPSA — FPS post system. A different mounting platform entirely, listed separately under FPS accessories.

An FPSA bracket will not attach to a cabinet frame, and an SA bracket will not attach to an FPS post. The prefix in the part number is the fastest way to confirm you have the right one.

Tech shelves and brackets

Tech shelves carry a camera, soundbar or codec above or below the display, sized by shelf dimension and post length — 24" and 36" posts cover most configurations. Specify post length against the display height and the camera position you actually want: a camera mounted too high looks down at participants, and one mounted too low looks up. Seated eye height is the target.

Feet, casters and finish

Feet and caster sets are ordered by quantity to match cabinet width — sets of 4, 6 and 8. Casters where the cabinet needs to move for cable access during service, fixed feet where it does not. Both are available in finishes matched to the cabinet range.

Order these with the cabinet

A tech shelf discovered during install turns a one-visit job into two, and factory-installed options are only available at the point of order. Creation Networks specifies the full assembly — cabinet, rack layout, mounts and accessories — against the room design. Call 888-230-3661 or email sales@creationnetworks.net.